Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running
the motor
Optimization
NV Media Card
Operation
Onboard
PLC
Advanced
parameters
Technical
data
Diagnostics
UL listing
information
Powerdrive F300 User Guide 105
Issue Number: 2
5.2.3 Quick access mode
The quick access mode allows direct access to any parameter without
scrolling through menus and parameters.
To enter the quick access mode, press and hold the Enter button
on the keypad while in ‘parameter mode’.
Figure 5-3 Quick access mode
5.2.4 Keypad shortcuts
In ‘parameter mode’:
• If the up and down keypad buttons are pressed
together, then the keypad display will jump to the start of the
parameter menu being viewed, i.e. Pr 05.005 being viewed, when
the above buttons pressed together will jump to Pr 05.000.
• If the left and right keypad buttons are pressed together,
then the keypad display will jump to the last viewed parameter in
Menu 0.
In ‘parameter edit mode’:
• If the up and down keypad buttons are pressed
together, then the parameter value of the parameter being edited will
be set to 0.
• If the left and right keypad buttons are pressed together, the
least significant digit (furthest right) will be selected on the keypad
display for editing.
Figure 5-4 Mode examples
1. Parameter view mode: Read write or Read only
2. Status mode: Drive OK status
If the drive is ok and the parameters are not being edited or viewed, the
upper row of the display will show one of the following:
• ‘Inhibit’, ‘Ready’ or ‘Run’.
3. Status mode: Trip status
When the drive is in trip condition, the upper row of the display will
indicate that the drive has tripped and the lower row of the display will
show the trip code. For further information regarding trip codes. refer to
Table 13-3 Trip indications on page 262.
4. Status mode: Alarm status
During an ‘alarm’ condition the upper row of the display flashes between
the drive status (Inhibit, Ready or Run, depending on what is displayed)
and the alarm.
When changing the values of parameters, make a note of the new
values in case they need to be entered again.
For new parameter-values to apply after the line power supply to the
drive is interrupted, new values must be saved. Refer to section
5.7 Saving parameters on page 108.
Do not change parameter values without careful
consideration; incorrect values may cause damage or a
safety hazard.
To Next Page
Loading...
