Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running
the motor
Optimization
NV Media Card
Operation
Onboard
PLC
Advanced
parameters
Technical
data
Diagnostics
UL listing
information
Powerdrive F300 User Guide 99
Issue Number: 2
4.12.2 Control terminal specification
1 0V common
Function
Common connection for all external
devices
2 +24V external input
Function
To supply the control circuit
without providing a supply to the
power stage
Programmability
Can be switched on or off to act as a digital
input by setting the source Pr 08.063 and
input invert Pr
08.053
Nominal voltage +24.0 Vdc
Minimum continuous operating
voltage
+19.2 Vdc
Maximum continuous operating
voltage
+28.0 Vdc
Minimum start-up voltage 21.6 Vdc
Recommended power supply 40 W 24 Vdc nominal
Recommended fuse 3 A, 50 Vdc
3
+24 V user output (selectable)
Terminal 3 default function +24 V user output
Programmability
Can be switched on or off to act as a fourth
digital output (positive logic only) by setting
the source Pr
08.028 and source invert
Pr
08.018
Nominal output current 100 mA combined with DIO3
Maximum output current
100 mA
200 mA (total including all Digital I/O)
Protection Current limit and trip
Sample / update period
2 ms when configured as an output (output
will only change at the update rate of the
source parameter if slower)
4 0V common
Function
Common connection for all external
devices
5 Analog input 1
6
Analog input 2
Terminal 5 Default function
Frequency / speed reference
(Pr 1.036)
Terminal 6 Default function
Frequency / speed reference
(Pr 1.037)
Type of input AI 1 [AI 2]
Unipolar current and Bipolar single-ended
analog voltage
Mode controlled by... Pr
07.007 [07.011]
Operating in current mode (Default for terminal 5)
Current ranges
0 to 20 mA ±5 %, 20 to 0 mA ±5 %,
4 to 20 mA ±5 %, 20 to 4 mA ±5 %
Maximum offset 250 μA
Absolute maximum voltage
(reverse bias)
±36 V relative to 0V
Absolute maximum current ±30 mA
Equivalent input resistance ≤ 300 Ω
Operating in voltage mode (Default for terminal 6)
Full scale voltage range ±10 V ±2 %
Maximum offset ±10 mV
Absolute maximum voltage range ±36 V relative to 0 V
Input resistance
≥100 k Ω
Common to all modes
Resolution 12 bits (11 bits plus sign)
Sample / update
250 µs with destinations Pr
01.036,
Pr
01.037 or Pr 03.022, Pr 04.008 in RFC-A
or RFC-S. 4 ms for open loop mode and all
other destinations in RFC-A or RFC-S
mode.
Operating in thermistor input mode
Voltage range ±10 V ±2 %
Supported thermistor types
Din 4408, KTY 84, PT100, PT 1000,
PT 2000, NI 1000
Internal pull-up voltage 5 V
Trip threshold resistance User defined in Pr
07.055 [07.060]
Reset resistance User defined in Pr 07.056 [07.061]
Short-circuit detection resistance 50 Ω ± 40 %
Common to all modes
Resolution
12 bits (11 bits plus sign)
Sample / update period
4 ms
To Next Page
Loading...
