Emerson Powerdrive F300 - Enclosure for Standard Drives; Recommended Spacing between the Drives; Spacing Required between the Drives

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running
the motor
Optimization
NV Media Card
Operation
Onboard
PLC
Advanced
parameters
Technical
data
Diagnostics
UL listing
information
46 Powerdrive F300 User Guide
Issue Number: 2
Table 3-3 Mounting brackets (size 11)
3.6 Enclosure for standard drives
3.6.1 Recommended spacing between the drives
Figure 3-33 Recommended spacing between the drives
Table 3-4 Spacing required between the drives (without high IP bung)
* 50°C derating applies, refer to Table 12-3 Maximum permissible
continuous output current @ 50 °C (122 °F) on page 235.
When through-panel mounted, ideally drives should be spaced 45 mm
(1.77 in) to maximize panel stiffness.
Frame size Surface Qty Through-panel Qty
11E
Hole size: 9 mm (0.35 in)
x 1 x 12
Hole size: 9 mm (0.35 in)
x 1
Hole size: 9 mm (0.35 in)
x 2
Drive Size
Spacing (A)
40°C 50°C*
3 0 mm (0.00 in)
4 0 mm (0.00 in)
5 0 mm (0.00 in) 30 mm (1.18 in)
6 0 mm (0.00 in)
7 30 mm (1.18 in)
8 30 mm (1.18 in)
9A/9E
60 mm (2.37 in)
10E/11E
Enclosure
A
NOTE