Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running
the motor
Optimization
NV Media Card
Operation
Onboard
PLC
Advanced
parameters
Technical
data
Diagnostics
UL listing
information
Powerdrive F300 User Guide 71
Issue Number: 2
Figure 4-3 Size 5 power connections
The upper terminal block (1) is used for AC supply connection.
The lower terminal block (2) is used for Motor connection.
If the heatsink mounted resistor is used, an overload protection device is not required. The resistor is designed to fail safely under fault conditions.
See Figure 4-10 for further information on ground connections.
L1 L2
L2L1 L3 U V W
Optional EMC
filter
Optional
line reactor
Fuses
L3
Mains
Supply
Motor
Optional ground
connection
Supply
Ground
PE
Supply Connections
Motor Connections
1
2
To Next Page
Loading...
