Emerson Powerdrive F300 - Removing the Finger-Guard and DC Terminal Cover Break-Outs; Removing the Size 7 to 11 Terminal Covers; Removing the Finger-Guard Break-Outs; Grommet Kits

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running
the motor
Optimization
NV Media Card
Operation
Onboard
PLC
Advanced
parameters
Technical
data
Diagnostics
UL listing
information
28 Powerdrive F300 User Guide
Issue Number: 2
Figure 3-9 Removing the size 7 to 11 terminal covers (size 7 shown)
When replacing the terminal covers, the screws should be tightened to a maximum torque of 1 N m (0.7 lb ft).
3.3.2 Removing the finger-guard and DC terminal cover break-outs
Figure 3-10 Removing the finger-guard break-outs
A: All sizes. B: Size 5 only. C: Size 6 only. D: Size 7 to 10.
Place finger-guard on a flat solid surface and hit relevant break-outs with
hammer as shown (1). Continue until all required break-outs are
removed (2). Remove any flash / sharp edges once the break-outs are
removed.
Grommet kits are available for size 7 to 10 finger guards. For size 8 to
10, two versions are available allowing for either single or double cable
entries.
Table 3-1 Grommet kits
Drive size
Quantity
of kits
Part number Picture
Size 7 - Kit of 8 x
single entry
grommets
1 3470-0086-00
Size 8 - Kit of 8 x
single entry
grommets
1 3470-0089-00
Size 8 - Kit of 8 x
double entry
grommets
1 3470-0090-00
Size 9E and 10E -
Kit of 8 x double
entry grommets
1
3470-0107-00
Size 11E- Kit of 8 x
double entry
grommets
2