Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running
the motor
Optimization
NV Media Card
Operation
Onboard
PLC
Advanced
parameters
Technical
data
Diagnostics
UL listing
information
Powerdrive F300 User Guide 147
Issue Number: 2
Select the discovered drive.
1. Select the ‘Online’ icon to connect with the drive. When a successful connection is made the icon will be highlighted orange.
2. Select ‘Set mode and region’.
If the required control mode is highlighted in the ‘Drive Settings’ dialogue, then:
• Change the supply frequency, if required and select ‘Apply’, otherwise select ‘Cancel’.
• Select ‘Default parameters‘ from the Dashboard and in the ‘Default Parameters’ dialogue, select ‘Apply’
If the required control mode is not highlighted in the ‘Drive Settings’ dialogue then:
• Select the required mode and supply frequency.
• Select ‘Apply’.
3. Select ‘Setup’ and perform the steps highlighted (dotted lines indicate a step which may not need to be performed (see overleaf):
4. Select 'Save parameters in drive' to perform a parameter save. The drive is now ready to run.
Action Detail
Motor Setup
Powerdrive F300 Connect contains a database for induction motors and permanent magnet motors. Provision is also made to
enter motor nameplate data.
The next section describes the use of the motor database for a Leroy Somer LSRPM motor used in RFC-S Sensorless mode.
Analog I/O
The motor thermistor can be selected in Pr 07.011. Refer to the parameter help for Pr 07.011 for further information.
Ramps Setup
Enter the required Acceleration rate and Deceleration rate
Autotune
Not required when using data from the motor database for a Leroy Somer LSRPM motor used in RFC-S Sensorless mode.
To Next Page
Loading...
