iTEMP TMT82 Operating menu and parameter description
Endress+Hauser 63
Expert → Sensor → Sensor n
1)
→ Sensor type n → 66
Connection type n → 67
2-wire compensation n → 67
Reference junction n → 67
RJ preset value → 68
Sensor offset n → 72
Sensor n lower limit → 95
Sensor n upper limit → 95
Sensor serial number → 95
1) n = number of sensor inputs (1 and 2)
Expert → Sensor → Sensor n → Sensor trimming→ Sensor trimming → 96
Sensor trimming lower
value
→ 96
Sensor trimming upper
value
→ 97
Sensor trimming min span → 97
Expert → Sensor → Sensor n
1)
→ Linearization→ Sensor n lower limit → 95
Sensor n upper limit → 95
Call./v. Dusen coeff. R0, A,
B, C
→ 98
Polynomial coeff. R0, A, B → 99
1) n = number of sensor inputs (1 and 2)
Expert → Sensor → Diagnostic settings → Corrosion detection → 72
Drift/difference mode → 73
Drift/difference alarm category → 73
Drift/difference alarm delay → 74
Drift/difference set point → 74
Sensor switch set point → 74
Calibration counter start → 99
Calibration alarm category → 100
Calibration counter start value → 100
Calibration countdown → 100
Expert → Output → Output current → 75
Measuring mode → 101
Lower range value → 69
Meas. range end → 69
Out of range category → 76
Failure mode → 76
Failure current → 76
To Next Page
Loading...
