Endress+Hauser Liquicap M FMI51 HART - Page 20

Mounting Liquicap M FMI51 HART
20 Endress+Hauser
61 (2.4)
41 (1.61)
B
H1
75 (2.95)
41 (1.61)
B
H3
H1
H5
D
r ≥ 100
r ≥ 100
A0040471
 8 Housing side: wall mounting, pipe mounting, and sensor side. Unit of measurement mm (in)
The parameters value
1)
:
B parameter
• polyester housing (F16)
76 mm (2.99 in)
• stainless steel housing (F15)
64 mm (2.52 in)
• aluminum housing (F17)
65 mm (2.56 in)
H1 parameter
• polyester housing (F16)
172 mm (6.77 in)
• stainless steel housing (F15)
166 mm (6.54 in)
• aluminum housing (F17)
177 mm (6.97 in)
D parameter
• probes ⌀10 mm (0.39 in) rod
38 mm (1.5 in)
• probes ⌀16 mm (0.63 in) rod, without fully insulated inactive length
• 38 mm (1.5 in)
• threads: G¾", G1", NPT¾", NPT1", Clamp 1", Clamp 1½", Universal ⌀44 mm (1.73 in),
flange < DN50, ANSI 2", 10K50
• probes ⌀16 mm (0.63 in) rod, without fully insulated inactive length
• 50 mm (1.97 in)
• threads: G1½", NPT1½", Clamp 2", DIN 11851, flange ≥ DN50, ANSI 2", 10K50
• Probes ⌀22 mm (0.87 in) rod, with fully insulated inactive length
38 mm (1.5 in)
1) See parameters on the drawings.