Endress+Hauser Liquicap M FMI51 HART - Page 35

Liquicap M FMI51 HART Operation options
Endress+Hauser 35
The second position refers to
the position is out of function
The third position refers to
the individual functions within the function group
Launching menus
The display automatically switches to the main screen with the measured value, if the
submenu is not chosen or the navigation key is not pressed for 15 minutes.
64.50
%
+
1
2
3
A0040488
1 Main menu button
2 Actual errors button
3 Measured value button
Measured value
displays the measured value in %, mA or pF
Main menu
• contains all the parameters of Liquicap M, and is split into submenus
• the submenus contain additional submenus
• to overview the menu, submenus, and all functions →  39
Actual errors
• if an error is detected, the display shows related softkey symbol over the center key
• if the symbol flashes than a warning was detected
• if the symbol is displayed continuously then an alarm-type error was detected
More information about the differences between "Alarm" and "Warning" →  76.
Press the center key to display the currently pending errors list.
Selecting a submenu
1. Press or to the select the submenu.
2. Press to enter the selected menu.
If the submenu contains additional submenus, continue in the same manner until you
reach the function level.
‣
Press or to select the function in submenu.
Return to the next-highest menu level any time by pressing "Escape" →  33.
If the menu has only one submenu then the soft keys are not displayed.