Endress+Hauser Liquicap M FMI51 HART - Page 94

Index Liquicap M FMI51 HART
94 Endress+Hauser
G
Green LED flashing .......................... 76
H
Hardware key combinations ....................33
HAW56x surge arrester .......................83
I
Incoming acceptance ......................... 12
Influence of ambient temperature ............... 86
Influence of process pressure ................... 86
Initial commissioning ........................ 44
Input .....................................85
Installation and function check ................. 39
Installation examples ........................ 16
Installation instructions .......................23
Interface measurement ....................... 72
K
Key locking ................................ 37
Key symbols ............................... 33
Key unlocking .............................. 37
L
Last errors ................................ 76
Launching menus ........................... 35
Linearization ...............................85
Locking and unlocking configuration ............. 37
M
M12 connector ............................. 27
Maintenance ...............................80
Maximum
measured error .......................... 86
Measured value is incorrect .................... 78
Measured value reaction time .................. 86
Measured variable ...........................85
Measuring condition ......................... 15
Measuring device
Conversion ..............................81
Disposal ................................82
Removing ...............................82
Repairs ................................ 81
Measuring range ............................85
Menu structures: Main menu ...................44
Menu: "Basic setup"
Commissioning with display and operating module
...................................... 44
Menu: "Device properties" ......................65
Menu: "Linearization" .........................55
Menu: "Output" ............................. 62
Menu: "Safety setting" ........................ 50
Menu: "Simulation" .......................... 65
Minimum probe length for nonconductive media .... 16
Mounting ................................. 13
Mounting requirements .......................14
Mounting the sensor ......................... 14
O
Operating conditions .........................88
Operating conditions: Process .................. 89
Operating mode: "Empty calibr."
Function - "Dry" ...........................48
Function - "Wet" .......................... 47
Operating mode: "Empty calibration"
Function - "Dry" for "Interface" or "Unknown"
medium properties ........................50
Operating mode: "Full calibr."
Function - "Wet" .......................... 48
Operating mode: "Full calibration"
Function - "Dry"
Conductive and nonconductive media ........49
Function - "Dry" for "Interface" or "Unknown"
medium properties ........................50
Operation ................................. 71
Operation options ........................... 31
Operation via FieldCare Device Setup ............. 38
Operation via the optional display and operating
module ................................... 32
Operational safety ...........................11
Output ................................... 85
Output signal .............................. 85
Overview of operation options .................. 31
P
Performance characteristics ....................86
Performing a reset ...........................38
Pipe mounting ............................. 22
Possible measuring errors ..................... 78
Post-connection check ........................30
Post-installation check ....................... 25
Potential equalization ........................ 26
Pressure and temperature derating .............. 91
Probe installation ........................... 24
Probe length ............................ 71, 84
Probe with PTFE-clad flange ................... 24
Probe with separate housing ................... 19
Probe with Tri-Clamp ........................ 24
Process pressure limits ....................... 90
Process temperature range .................... 89
Product identification ........................ 12
Product safety ..............................11
Protective cover .............................83
Q
Quick installation guide .......................13
R
Red LED flashing ............................76
Reference operating conditions ................. 86
Registered trademarks ........................10
Repair ....................................81
Repairing Ex-certified devices .................. 81
Replacement ...............................82
Device components ........................81
Requirements for the personnel .................11
Resetting to factory setting - reset ............... 38
Resolution .................................87
Response time ..............................87