Endress+Hauser Liquiline CA80SI - Page 68

Operation Liquiline System CA80SI
68 Endress+Hauser
Menu/Setup/Analyzer/Extended setup
Function Options Info
Diag. code 727 Read only
Absorption curve recording
In automatic mode Selection
• Off
• On
Factory setting
Off
Off: Recording is only possible in the manual
mode
On: Recording also takes place in the automatic
mode
Curve Selection
1 to 7
Factory setting
3
Select the absorption curve to be recorded.
Only one curve can be selected at any one time.
The data are saved in a logbook.
After power failure Selection
• Last mode
• Manual mode
Factory setting
Last mode
Setting specifying how the analyzer should
behave after a power failure, or when the power
is back on.
Last mode: The analyzer remains in the mode
that was last set. Example: The automatic mode
was set. The analyzer continues after
initialization and after any samples have been
discarded.
Manual mode: The analyzer switches to the
manual mode and waits for user action.
Timeout no sample Selection
0:00 to 30:00 mm:ss
Factory setting
1:00 (MM:SS)
Maximum time the device waits for sufficient
sample flow
11.2.2 Measurement
Menu/Setup/Analyzer/Measurement
Function Options Info
Start condition Selection
• Immediate
• Date/time
Factory setting
Immediate
Immediate: The analyzer immediately starts
with the measurement cycle once the system
changes to the automatic mode.
Date/time: The analyzer starts with the
measurement cycle at the set date/time.
If the start condition selected is Immediate
Measuring interval Factory setting For configuring the time interval of the
measurement
If the start condition selected is Date/time
Date 01.01.1970 to 07.02.2106
Factory setting
DD.MM.YYYY
Time 00:00:00 to 23:59:59
Factory setting
HH:MM:SS (24 h)
Measuring interval Factory setting For configuring the time interval of the
measurement