Endress+Hauser Proline Promass E TB2 HART - Page 113

Proline Promass E TB2 HART Index
Endress+Hauser 113
For the local display ......................59, 71
For totalizer ..............................70
Patents ....................................11
Performance characteristics .....................100
Post-connection check (checklist) .................28
Post-mounting check (checklist) ..................24
Potential equalization ..........................99
Power consumption ...........................99
Power supply (Supply voltage) .................27, 99
Power supply failure ...........................99
Pressure Equipment Directive ...................109
Pressure loss ...............................104
in SI units ..............................104
in US units ..............................105
Pressure range
Medium ...............................103
Secondary containment .....................103
Process connection ..........................107
Process variables
Calculated ...............................97
Measured ...............................97
Product safety ................................9
Protecting parameter settings .....................74
Protocol-specific data ..........................99
R
Read access .................................43
Reading off measured values .....................77
Recalibration ................................93
Reference operating conditions ..................100
Registered trademarks .........................10
Remedial measures
Calling up ...............................83
Close ..................................83
Remote operation ...........................108
Repair ....................................91
Concept ................................91
Notes ..................................91
Repair of a device ............................91
Repeatability ...............................101
Replacement
Device components .........................91
Requirements for personnel .......................8
Response time ..............................101
Returning the measuring device ...................95
Rupture disk
Safety instructions ..........................21
Triggering pressure ........................103
Use ...................................105
S
Safety
Safety instructions ..........................8
Safety symbols .............................6
Safety icons
see Safety
Seals
Medium temperature range ..................103
Secondary containment pressure range .............103
Sensor
Medium temperature range ..................103
Mounting ...............................22
Sensor heating ...............................20
Serial number ............................13, 14
Setting the operating language ....................51
Settings
Adapting the measuring device to the process conditions
......................................78
Advanced display configurations ................71
Current outputs ...........................55
Device tag ...............................67
local display ..............................59
Low flow cut off ...........................64
Manage device configuration ..................72
Medium ................................53
Monitoring of the tube filling ..................65
Operating language ........................51
Output conduct ...........................61
Reset totalizers ............................78
Sensor adjustment .........................69
Simulation ...............................73
System units .............................67
Totalizer ................................70
Totalizer reset ............................78
Shock resistance ............................103
Show measured value history ....................79
Signal on alarm ..............................98
SIMATIC PDM ..............................46
Function ................................46
SIP cleaning ...............................103
Software release .............................49
Spare part ..................................91
Spare parts .................................91
Concept ................................91
Nameplate ...............................91
Standards and guidelines .......................108
Status area
For measured value display ...................33
In navigation view .........................35
Status signals ................................82
Storage and transportation conditions ...............15
Storage temperature ...........................15
Structure
Measuring device ..........................10
Submenu
Data logging ..............................79
Events list ...............................88
Local display .............................71
Operation ...............................78
Output value .............................77
Process variab. ............................77
Sensor adjustment .........................69
Simulation ...............................73
System units .............................67
Totalizer .............................70, 77
Submenus .................................32
Supply unit
Requirements .............................27