Endress+Hauser Proline Promass F 300 - Configuring the Communication

Proline Promass F 300 EtherNet/IP Commissioning
103
Parameter Description Selection Factory setting
Density unit Select density unit.
Result
The selected unit applies for:
• Output
• Simulation process variable
• Density adjustment (Expert menu)
Unit choose list Country-specific:
• kg/l
• lb/ft³
Reference density unit Select reference density unit. Unit choose list Country-dependent
• kg/Nl
• lb/Sft³
Temperature unit Select temperature unit.
Result
The selected unit applies for:
• Electronic temperature parameter
(6053)
• Maximum value parameter (6051)
• Minimum value parameter (6052)
• External temperature parameter (6080)
• Maximum value parameter (6108)
• Minimum value parameter (6109)
• Carrier pipe temperature parameter
(6027)
• Maximum value parameter (6029)
• Minimum value parameter (6030)
• Reference temperature parameter
(1816)
• Temperature parameter
Unit choose list Country-specific:
• °C
• °F
Pressure unit Select process pressure unit.
Result
The unit is taken from:
• Pressure value parameter (→  106)
• External pressure parameter
(→  106)
• Pressure value
Unit choose list Country-specific:
• bar a
• psi a
10.5.3 Configuring the communication interface
The Communication submenu guides you systematically through all the parameters that
have to be configured for selecting and setting the communication interface.
Navigation
"Setup" menu → Communication
‣
Communication
MAC address
→  104
Default network settings
→  104
DHCP client
→  104
IP address
→  104