Endress+Hauser Proline Promass F 300 - Displaying the I;O Configuration; Configuring the Current Input

Proline Promass F 300 EtherNet/IP Commissioning
107
10.5.5 Displaying the I/O configuration
The I/O configuration submenu guides the user systematically through all the parameters
in which the configuration of the I/O modules is displayed.
Navigation
"Setup" menu → I/O configuration
‣
I/O configuration
I/O module 1 to n terminal numbers
→  107
I/O module 1 to n information
→  107
I/O module 1 to n type
→  107
Apply I/O configuration
→  107
Alteration code
→  107
Parameter overview with brief description
Parameter Description User interface / Selection /
User entry
Factory setting
I/O module 1 to n terminal numbers Shows the terminal numbers used by the I/O
module.
• Not used
• 26-27 (I/O 1)
• 24-25 (I/O 2)
• 22-23 (I/O 3)
–
I/O module 1 to n information Shows information of the plugged I/O
module.
• Not plugged
• Invalid
• Not configurable
• Configurable
• EtherNet/IP
–
I/O module 1 to n type Shows the I/O module type. • Off
• Current output
*
• Current input
*
• Status input
*
• Pulse/frequency/switch
output
*
Off
Apply I/O configuration Apply parameterization of the freely
configurable I/O module.
• No
• Yes
No
Alteration code Enter the code in order to change the I/O
configuration.
Positive integer 0
* Visibility depends on order options or device settings
10.5.6 Configuring the current input
The "Current input" wizard guides the user systematically through all the parameters that
have to be set for configuring the current input.