Installing a Second IOM
2-8 Installation
2. Remove the screws from the access panel on the bottom of the switch, then remove the panel,
as shown in Figure 2-3 on page 2-8.
3. Remove the front blank plate by removing the two screws then pushing in the panel at the
bottom (closest to the surface where the switch is resting). Remove the panel and save the two
screws.
Figure 2-3 Removing the Access Panel and Blank Front Plate
4. Inside the switch, remove the cover from the heat block, shown in Figure 2-4 on page 2-9.
Make sure that the heat transfer pad (sticky pad) remains on the block.
1 Blank front plate screws (2) 3 Access panel
2 Blank front plate 4 Access panel screws (8)
To Next Page
Loading...
Need help?
General