Enterasys I Series - Appendix A: Specifications and Regulatory Compliance; Physical Specifications; Regulatory Compliance; Switch Specifications

Enterasys I-Series Hardware Installation Guide A-1
A
Specifications and Regulatory Compliance
This appendix provides operating specifications for the Enterasys I-Series switch.
Enterasys Networks reserves the right to change the specifications at any time without notice.
Physical Specifications
The physical specifications for the I-Series switch and the IOMs are as follows:
For information about... Refer to page...
Physical Specifications A-1
Power Requirements A-3
Environmental Requirements A-3
IOM Port Specifications A-3
Relay Specifications A-5
Mini-GBIC Input/Output Specifications A-5
Regulatory Compliance A-7
Table A-1 Switch Specifications
Physical Specification
Dimensions
8.89 cm x 33.86 cm x 18.41 cm
(3.5 in. x 13.33 in. x 7.25 in.)
Weight of chassis without any IOMs 4.11 kg (9.05 lb)
Predicted hours for Mean Time Between
Failures (MTBF)
Information about MTBF is located at
http://www.enterasys.com/support/mtbf.