Enterasys Matrix E1 1G694-13 Installation Guide

How to Use This Guide
About This Guide xv
HOW TO USE THIS GUIDE
RELATED DOCUMENTS
The following document provides the information to configure the switch using the Command
Line Interface to set up and manage the switch:
Matrix E1 1G694-13 Configuration Guide
The manual listed above can be obtained from the World Wide Web in Adobe Acrobat Portable
Document Format (PDF) at the following site:
http://www.enterasys.com/support/manuals
For... Refer to...
An overview of the switch and getting
technical support from Enterasys Networks
Chapter 1, Introduction
Network requirements that must be met
before installing the switch
Chapter 2, Network Requirements
Instructions to install the switch hardware
and optional modules
Chapter 3, Hardware Installation
Troubleshooting installation problems and
diagnosing network/operational problems
using the LANVIEW LEDs
Chapter 4, Troubleshooting
Specifications, environmental requirements,
and physical properties for the 1G694-13
and its optional modules
Appendix A, Specifications
Instructions to set the mode switches when
necessary
Appendix B, Mode Switch Bank Settings

Enterasys Matrix E1 1G694-13 Specifications

General

Brand	Enterasys
Model	Matrix E1 1G694-13
Category	Switch
Language	English