10Base Half
Uses 10base-T half-duplex.
10Base Full
Uses 10base-T full-duplex.
100Base Half
Uses 100base-TX half-duplex.
100Base Full
Uses 100base-TX full-duplex.
Note:
This item is displayed only when the printer is connected with a wired network.
Wireless Status (Epson AcuLaser C1750W Only)
Purpose:
To display the information on the wireless signal strength. No changes can be made on the operator
panel to improve the status of the wireless connection.
Values:
Good
Indicates good signal strength.
Acceptable
Indicates marginal signal strength.
Low
Indicates insufficient signal strength.
No Reception
Indicates that no signal is received.
Note:
This item is displayed only when the printer is connected with a wireless network.
Wireless Setup (Epson AcuLaser C1750W Only)
Purpose:
To configure the wireless network interface.
Epson AcuLaser C1750 Series User’s Guide
Using the Operator Panel Menus 134
To Next Page
Loading...
Need help?
General