Auger Mark
Problem Action
The printed result has auger mark. The toner cartridges may be low or need to be replaced. Confirm the amount of
toner in each toner cartridge.
1. Check the toner level in the Status tab in the Status Monitor window.
2. Replace the toner cartridges as necessary.
Start Developer Stir Mode.
1. Launch the Printer Setting Utility, and click Developer Stir Mode on the
Diagnosis tab.
2. Click the Start button.
Note:
If the problem continues even though you have taken suggested actions described above, contact the
Epson local representative office or an authorised dealer.
Wrinkled/Stained Paper
Epson AcuLaser C1750 Series User’s Guide
Troubleshooting 171
To Next Page
Loading...
