Problem Action
The printed result is foggy. When the whole is printed light, contact the Epson local representative office or an
authorised dealer.
When the printed page is partly light, start Developer Stir Mode.
1. Launch the Printer Setting Utility, and click Developer Stir Mode on the
Diagnosis tab.
2. Click the Start button.
Note:
If the problem continues even though you have taken suggested actions described above, contact the
Epson local representative office or an authorised dealer.
Bead-Carry-Out (BCO)
Problem Action
Bead-Carry-Out (BCO) is happening. If the printer is installed in a high altitude location, set the altitude of the location.
1. Launch the Printer Setting Utility, and click Adjust Altitude on the Printer
Maintenance tab.
2. Select the value close to the altitude of the location where the printer is installed.
3. Click the Apply New Settings button.
Note:
If the problem continues even though you have taken suggested actions described above, contact the
Epson local representative office or an authorised dealer.
Epson AcuLaser C1750 Series User’s Guide
Troubleshooting 170