Chapter 7
Troubleshooting
Clearing Jams
Careful selection of appropriate print media and proper loading allow you to avoid most jams.
See also:
❏ “About Print Media” on page 91
❏ “Supported Print Media” on page 92
Note:
Before buying large quantities of any print media, it is recommended that you try a sample first.
Avoiding Jams
❏ Use only recommended print media.
❏ See “Loading Print Media in the Multipurpose Feeder (MPF)” on page 96 and “Loading Print
Media in the Priority Sheet Inserter (PSI)” on page 105 to load print media properly.
❏ Do not overload the print media sources. Ensure that the stacked print media does not exceed the
maximum height indicated on the paper width guides.
❏ Do not load wrinkled, creased, damp, or curled print media.
❏ Flex, fan, and straighten print media before you load it. If a jam occurs with print media, try
feeding one sheet at a time through the MPF or the PSI.
❏ Do not use print media that you have cut or trimmed.
❏ Do not mix print media sizes, weights, or types in the same print media source.
❏ Ensure that the recommended print side is face up when you insert the print media.
❏ Keep print media stored in an acceptable environment.
❏ Do not remove the PSI during a print job.
❏ Ensure that all cables that connect to the printer are correctly attached.
Epson AcuLaser C1750 Series User’s Guide
Troubleshooting 152
To Next Page
Loading...
Need help?
General