Epson AcuLaser C1750N - System Setup; PowerSaver Time

USB Setup
Use the USB Setup menu to change printer settings affecting a USB port.
Note:
Values marked by an asterisk (*) are the factory default menu settings.
Port Status
Purpose:
To change the USB settings on your printer. The change becomes effective after the printer is turned
off and then on.
Values:
Disable
Disables the USB interface.
Enable*
Enables the USB interface.
System Setup
Use the System Setup menu to configure the power saving mode, time-out time, job log auto print,
mm/inch setting, default paper size setting, and low toner alert setting.
Note:
Values marked by an asterisk (*) are the factory default menu settings.
PowerSaver Time
Purpose:
To specify the time for transition to Power Saver Mode.
Values:
Mode1 5min.*
Specifies the time taken by the printer before it enters Mode1 after it
finishes a job.
5–30min.
Mode2 6min.*
Specifies the time taken by the printer before it enters Mode2 after it
goes into Mode1.
1–6min.
Epson AcuLaser C1750 Series User’s Guide
Using the Operator Panel Menus 139