Epson AcuLaser C1750N User Manual

Print Quality Problems
Note:
In this section, some procedures use the Printer Setting Utility or Status Monitor. Some procedures that
use the Printer Setting Utility can also be performed using the operator panel.
See also:
❏ “Understanding the Printer Menus” on page 132
❏ “Printer Setting Utility (Windows Only)” on page 21
❏ “Status Monitor (Windows Only)” on page 22
The Output Is Too Light
Problem Action
The output is too light. The toner cartridges may be low or need to be replaced. Confirm the amount of
toner in each toner cartridge.
1. Check the toner level in the Status tab in the Status Monitor window.
2. Replace the toner cartridges as necessary.
Verify that the print media is dry and the correct print media is used.
If not, use the print media recommended for the printer.
See also:
“Usable Print Media” on page 93
Try changing the Paper Type setting in the print driver.
1. On the Paper / Output tab in Printing Preferences of the print driver, change
the Paper Type setting.
Disable Draft Mode in the print driver.
1. On the Advanced Settings tab in Printing Preferences of the print driver,
ensure that the Draft Mode check box is not selected.
Epson AcuLaser C1750 Series User’s Guide
Troubleshooting 164

Epson AcuLaser C1750N Specifications

General

Brand	Epson
Model	AcuLaser C1750N
Category	Printer
Language	English