Chapter 4
Network Basics
Overview of Network Setup and Configuration
To set up and configure the network:
1. Connect the printer to the network using the recommended hardware and cables.
2. Turn on the printer and the computer.
3. Print the Printer Settings page and keep it for referencing network settings.
4. Install the driver software on the computer from the Software Disc. For information on driver
installation, see the section in this chapter for the specific operating system you are using.
5. Configure the printer’s TCP/IP address, which is required to identify the printer on the network.
❏ Microsoft
®
Windows
®
operating systems: Run the Installer on the Software Disc to
automatically set the printer’s Internet Protocol (IP) address if you connect the printer to an
established TCP/IP network. You can also manually set the printer’s IP address on the
operator panel.
❏ Mac OS
®
X systems: Manually set the printer’s TCP/IP address on the operator panel.
6. Print a Printer Settings page to verify the new settings.
See Also:
“Printing a Printer Settings Page” on page 125
Connecting Your Printer
Your Epson AcuLaser C1750 series interconnection cables must meet the following requirements:
Connection Type Connection Specifications
Ethernet 10 Base-T/100 Base-TX compatible
USB USB 1.1/2.0 compatible
Epson AcuLaser C1750 Series User’s Guide
Network Basics 24
To Next Page
Loading...
Need help?
General