Epson AcuLaser C1750N User Manual

You can turn on/off both protocols using the operator panel, or use EpsonNet Config to turn on/off
DHCP.
Note:
You can print a report that includes the printer’s IP address. On the operator panel, press the
(Menu)
button, select Information Pgs, press the
button, select Printer Settings, and then press the
button. The IP address is listed on the Printer Settings page.
Using the Operator Panel
To turn on/off either the DHCP or AutoIP protocol:
1. On the operator panel, press the
(Menu) button.
2. Select Admin Menu, and then press the
button.
3. Select Network Setup, and then press the
button.
4. Select TCP/IP, and then press the
button.
5. Select IPv4, and then press the
button.
6. Select Get IP Address, and then press the
button.
7. Select DHCP/AutoIP, and then press the
button.
Using EpsonNet Config
To turn on/off the DHCP protocol:
1. Launch your web browser.
2. Enter the IP address of the printer in the address bar, and then press the Enter key.
3. Select Properties.
4. Select TCP/IP from the Protocol Settings folder on the left navigation panel.
5. In the Get IP Address field, select the DHCP / Autonet option.
6. Click the Apply button.
Epson AcuLaser C1750 Series User’s Guide
Network Basics 29

Epson AcuLaser C1750N Specifications

General

Brand	Epson
Model	AcuLaser C1750N
Category	Printer
Language	English