12. Press the button.
The next digit is selected.
13. Repeat steps 11 to 12 to enter all of the digits in the IP address, and then press the
button.
14. Press the
(Back) button, and then ensure that IP Address is selected.
15. Select Network Mask, and then press the
button.
The cursor is located at the first digit of the network mask.
16. Enter the value of the network mask using the
or button.
17. Press the
button.
The next digit is selected.
18. Repeat steps 16 to 17 to set network mask, and then press the
button.
19. Press the
(Back) button, and then ensure that Network Mask is selected.
20. Select Gateway Address, and then press the
button.
The cursor is located at the first digit of the gateway address.
21. Enter the value of the gateway address using the
or button.
22. Press the
button.
The next digit is selected.
23. Repeat steps 21 to 22 to set gateway address, and then press the
button.
24. Turn off and turn on the printer.
See Also:
“Operator Panel” on page 16
The Printer Setting Utility
The following procedure uses Windows XP as an example.
Epson AcuLaser C1750 Series User’s Guide
Network Basics 31
To Next Page
Loading...
