Epson AcuLaser C1750N - Page 73

d
Ensure that the check box for Use Windows to configure my wireless network settings
is selected.
e
Click Advanced.
f You can either set the printer to the ad-hoc mode or the infrastructure mode.
❏ For Ad hoc mode:
Select Computer-to-computer (ad hoc) networks only and close the dialog box.
❏ For Infrastructure mode:
Select Access point (Infrastructure) networks only and close the dialog box.
g
Click Add to display Wireless network properties.
h
Enter the setting that you will send to the printer and click OK.
i
Click Move up to move the setting to the top of the list.
j
Click OK to close the Wireless Network Connection Properties dialog box.
For Windows Vista:
a
Display Control Panel.
b
Select Network and Internet.
c
Select Network and Sharing Center.
d
Select Connect to a network.
e
Select the network, and then click Connect.
f
Click Close in the dialog box after confirming the connection is a success.
For Windows Server 2008:
a
Display Control Panel.
b
Select Network and Internet.
c
Select Network and Sharing Center.
Epson AcuLaser C1750 Series User’s Guide
Network Basics 73