196 Installing Options
Removing an interface card
Perform the installation procedure in reverse.
Printing a Status Sheet
To confirm that the options are installed correctly, print a status
sheet using the printer’s control panel.
1. Turn on the printer. The LCD panel shows Ready.
2. Press the Enter button three times. The printer prints a
status sheet.
3. Confirm that the information about the installed options is
correct. If the options are installed correctly, they appear
under Hardware Configurations. If the options are not listed,
try reinstalling them.
Note:
❏ If the status sheet does not list your installed options correctly, make
sure that they are securely connected to the printer.
❏ If you are unable to get the printer to print a correct status sheet,
contact your dealer.
Enter button
To Next Page
Loading...
