296 Troubleshooting
Status and Error Messages
This section contains a list of error messages shown on the LCD
panel, giving a brief description of each message and suggestions
for correcting the problem. Note that not every message shown
on the LCD panel indicates a problem.
Calibrating Printer
The printer automatically calibrates itself when any of its covers
are opened and there is no error inside. This is not an error
message, and will clear itself after a few minutes. While the
printer displays this message, do not open the covers or turn off
the printer.
Cancel All Print Job
The printer is canceling all print jobs in the printer memory,
including jobs the printer is currently receiving or printing. This
message appears when the Cancel Job button has been pressed
down for more than 2 seconds.
There may be no paper in the
cassette or MP tray.
Load paper.
Too many sheets may be
loaded in a cassette or MP tray.
Make sure that you have not tried to
load too many sheets of paper. For the
maximum paper capacity for each
paper source, see “MP tray” on page 33.
If paper does not feed from the
optional 500-Sheet Paper
Cassette Unit, the unit may not
be installed properly.
For instructions on installing the unit,
see “500-Sheet Paper Cassette Unit” on
page 169.
To Next Page
Loading...
