Troubleshooting 293
10
10
10
10
10
10
10
10
10
10
10
10
Areas are missing in the printed image
Completely blank pages are output
Cause What to do
Your paper may be moist or
damp.
This printer is sensitive to moisture
absorbed by the paper. The higher the
moisture content in the paper, the
lighter the printout. Do not store paper
in a humid or damp environment.
You may not be using the
correct type of paper for your
printer.
If the surface of your paper is too rough,
printed characters may appear
distorted or broken. EPSON special
paper or smooth, high-quality copier
paper is recommended for best results.
See “Available Paper” on page 29 for
information on choosing paper.
Cause What to do
The printer may have loaded
more than one sheet at a time.
Remove the paper stack and fan it. Tap
it on a flat surface to even the edges.
Then reload the paper.
There may be no toner left in
the developer cartridge.
If the message on the LCD panel or in
the EPSON Status Monitor 3 utility
indicates that the amount of toner is
low, see “Developer Cartridge” on page
242.
There may be a problem with
the photoconductor unit.
Replace the photoconductor unit. See
“Photoconductor Unit” on page 246.
To Next Page
Loading...
