Troubleshooting 285
10
10
10
10
10
10
10
10
10
10
10
10
You may not be using the
correct interface cable.
If you are using the parallel interface,
make sure that the cable is a
double-shielded, twisted-pair interface
cable no more than six feet in length.
If you are using the USB interface, use a
Revision 1.1 cable.
The emulation setting for the
port may not be correct.
Specify the emulation mode by using
the printer’s control panel menus. See
“Emulation Menu” on page 210.
Note:
If a status sheet does not print correctly, your printer may be damaged. Contact
your dealer or a qualified service representative.
To Next Page
Loading...
