Troubleshooting 299
10
10
10
10
10
10
10
10
10
10
10
10
If Off is selected as the Auto Cont setting on the control panel’s
Setup Menu, press the Start/Stop button to print on the back of
the next sheet, or press the Cancel Job button to cancel the print
job.
If On is selected as the Auto Cont setting on the control panel’s
Setup Menu, printing continues automatically after a certain
period of time.
Format Error ROM A
An unformatted ROM module has been inserted. If the ROM
module has been formatted, but is still unreadable, format it
again. If the ROM is still unreadable after reformatting, take the
module to your dealer for repair or replacement.
To clear this error, either press the
Start/Stop button or turn off
the printer and remove the ROM module.
Formatting HDD
The printer is formatting the optional Hard Disk Drive.
Form Data Canceled
Unable to store form overlay data on the printer’s Hard Disk
Drive. Either the drive is full, or the maximum number of form
overlay files has been reached. Delete any form overlay files you
no longer need, then try storing the new overlay again.
To clear this error, select Clear Warning from the control panel’s
Reset Menu. See “How to access the control panel menus” on page
199 for instructions.
Form Feed
The printer is ejecting paper due to a printing error. This message
appears when the
Start/Stop button has been held down for more
than 2 seconds in order to recover from a printing error.
To Next Page
Loading...
