Sub-menu Function
IP Settings
(This can be set only if Connection Mode is set to Advanced.)
You can make network settings.
DHCP: Set to On to make network settings using
DHCP
g
. If this
is set to On, you cannot set any more addresses.
IP Address: You can input the
IP address
g
assigned to the
projector. You can enter a number from 0 to 255 in each field of
the address. However, the following IP addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
Subnet Mask: You can input the
subnet mask
g
for the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following subnet masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address: You can input the IP address for the gateway
for the projector. You can enter a number from 0 to 255 in each
field of the address. However, the following
Gateway addresses
g
cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
SSID Display
To prevent the
SSID
g
from being displayed on the LAN Standby
screen, set this to Off.
IP Address Dis‐
play
To prevent the
IP address
g
from being displayed on the LAN
Standby screen, set this to Off.
Security Menu
Sub-menu Function
Security
Select the security type from the items that are displayed.
When setting security, follow the instructions from the
administrator of the network system you are about to access.
Passphrase
(This can only be selected when Security is set to WPA2-PSK or
WPA/WPA2-PSK.)
Enter the passphrase. You can enter at least 8 and up to 63 single-
byte alphanumeric characters.
When using with EasyMP Network Projection, you do not need
to enter the passphrase in the computer if it is the initial (default)
passphrase.
s "Reset Menu" p.135
You can enter up to 32 characters on the Configuration menu.
When entering more than 32 characters, use your Web browser
to enter the text.
s "Changing Settings Using a Web Browser (Web Control)"
p.105
When Connection Mode is set to Quick, the initial passphrase is
set.
List of Functions
131
To Next Page
Loading...
Need help?
General
