Remote Control
Name Function
A
[Power] button
[
t
]
Turns the projector power on or off.
s "Getting Ready to Project" p.44
B
[Computer] button
Each time you press the button, the input changes between
images from the Computer1 port and the Computer2
port.
C
[Video] button
Each time the button is pressed, the image cycles through
the S-Video, Video, HDMI1/MHL, and HDMI2 ports.
D
Numeric buttons
• Enter the Password.
s "Setting Password Protection" p.101
• Use this button to enter numbers in Network settings
from the Configuration menu.
E
[Auto] button
If pressed while projecting analog RGB signals from
Computer1 port or Computer2 port, you can
automatically optimize Tracking, Sync., and Position.
F
[Aspect] button
Each time the button is pressed, the aspect mode changes.
s "Changing the Aspect Ratio of the Projected Image"
p.59
G
[Num] button
Hold down this button and press the numeric buttons to
enter passwords and numbers.
s "Setting Password Protection" p.101
H
[Menu] button
Displays and closes the Configuration menu.
s "Using the Configuration Menu" p.116
Part Names and Functions
17
To Next Page
Loading...
