a
• You can make settings so that images are projected from the same
input port the next time the projector is turned on.
s Extended - Operation - Startup Source Search p.123
• The following screen is displayed while no image signals are input.
Switching to the Target Image Using the Remote
Control
You can change directly to the target image by pressing the following
buttons on the remote control.
Remote control
A
Each time the button is pressed, it cycles through the images being input
from the following sources.
• Computer1 port
• Computer2 port
B
Each time the button is pressed, it cycles through the images being input
from the following sources.
• S-Video port
• Video port
• HDMI1/MHL port
• HDMI2 port
C
Each time the button is pressed, it cycles through the images being input
from the following sources.
• USB Display
• Images from the device connected to the USB-A port
D
Switches to the image from the network connected device.
Projecting Images
46
To Next Page
Loading...
Need help?
General
