The Mouse Cursor Flickers (only when Projecting USB Display)
Check Remedy
Is Make the movement of the mouse pointer smooth. selected? Click All Programs - EPSON Projector - Epson USB Display - Epson USB Display Ver.x.xx Settings, and then select
the Make the movement of the mouse pointer smooth. checkbox. (Windows 2000 is unavailable.)
Windows Aero becomes unavailable if this is selected in Windows 7 and Windows Vista.
The Image Is Truncated (Large) or Small, or the Aspect Is Not Suitable
Check Remedy
Is a wide-panel computer image being projected?
(Only when projecting computer images)
Change the setting according to the signal for the connected equipment.
s Signal - Resolution p.120
Is the image still being enlarged by E-Zoom? Press the [Esc] button on the remote control to cancel E-Zoom.
s "Enlarging Part of the Image (E-Zoom)" p.94
Is the display position adjusted correctly? (Only when projecting analog RGB signals input from the Computer1 or Computer2 port)
Press the [Auto] button on the remote control or the [Enter] button on the control panel to adjust the position.
You can also adjust the position from the Configuration menu.
s Signal - Position p.120
Is the computer set for dual display?
(Only when projecting computer images)
If dual display is activated in the Display Properties of the computer's Control Panel, only about half of the image on the
computer screen is projected. To display the entire image on the computer screen, turn off the dual display setting.
s Computer video driver documentation
Is the correct resolution selected?
(Only when projecting computer images)
Set the computer so that the signals being output are compatible with the projector.
s "Supported Monitor Displays" p.178
s Computer's documentation
Did you adjust the image position after performing Adjust Zoom or
Keystone?
Perform Image Shift to adjust the image position after performing Adjust Zoom or Keystone.
s "Adjusting the Position of the Image (Image Shift)" p.53
Is the projection mode correct? Depending on how the projector is installed, set Projection from one of the following: Front, Front/Upside Down,
Rear, Rear/Upside Down.
s Extended - Projection p.123
s "Installation Methods" p.25
Problem Solving
150
To Next Page
Loading...
Need help?
General
