c
Use the [ ], [ ], [ ], and [ ] buttons to position the cursor
over OK, and then press the [Enter] button.
The settings are applied.
If you do not want to apply the settings, position the cursor on
Cancel, and then press the [Enter] button.
Hiding the Image and Sound Temporarily (A/V
Mute)
You can switch off the image on the screen when you want to focus the
audience's attention on what you are saying, or when you do not want to
display operations such as changing files.
Each time you press the [A/V Mute] button, A/V Mute turns on or off.
Remote control
a
• If you use this function when projecting moving images, the images
and sound continue to be played back by the source, and you cannot
return to the point where A/V Mute was activated.
• Microphone audio is still output even when A/V Mute is turned
on.
• You can select the screen displayed when the [A/V Mute] button is
pressed from the Configuration menu.
s Extended - Display - A/V Mute p.123
• When A/V mute is enabled with the [A/V Mute] button, A/V Mute
Timer activates and the power is automatically turned off after
approximately 30 minutes. If you do not want to enable A/V Mute
Timer, set A/V Mute Timer to Off.
s ECO - A/V Mute Timer p.135
• The lamp is still lit during A/V Mute, so the lamp hours continue to
accumulate.
Freezing the Image (Freeze)
When Freeze is activated on moving images, the frozen image continues to
project on the screen, so you can project a moving image one frame at a
time like a still photo. Also, you can perform operations such as changing
between files during presentations from a computer without projecting any
images if the Freeze function is activated beforehand.
Each time you press the [Freeze] button, Freeze turns on or off.
Remote control
Projection Functions
93
To Next Page
Loading...
Need help?
General
