Problems when Projection Starts
The Projector Does Not Turn on
Check Remedy
Did you press the [t] power button? Press the [t] power button to turn the power on.
Are all of the indicators off? The power cord is not connected correctly or power is not being supplied.
Disconnect and then reconnect the power cord.
s
"Getting Ready to Project" p.44
Check the breaker and so on to ensure power is being supplied.
Do the indicators turn on and off when the power cord is touched? There is probably a poor contact in the power cord, or the power cord may be defective. Reinsert the power cord. If this
does not solve the problem, stop using the projector, disconnect the power cord from the electrical outlet, and contact
your local dealer or the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
Is the Control Panel Lock set to Full Lock? Press the [t] power button on the remote control. If you do not want to use Control Panel Lock, change the setting to
Off.
s Settings - Control Panel Lock p.122
Is remote control operation restricted? Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver p.122
Problems with the Interactive Features (EB-585Wi/EB-575Wi only)
Cannot Draw on the Projected Screen
Check Remedy
Has pen calibration been performed correctly? Make sure you perform pen calibration when using the interactive pen for the first time so that the projector recognizes
the position of the pen correctly.
Also, calibrate the system again if you notice any discrepancy in positioning.
s "Pen Calibration" p.71
Is Pen Mode set to PC Interactive?Set Pen Mode to PC Free Annotation from the Configuration menu.
s Extended - Easy Interactive Function - Pen Mode p.126
Problem Solving
152