a
After projecting the image, adjust the image if necessary.
s "Correcting Keystone Distortion" p.50
s "Correcting the Focus" p.55
Automatically Detect Input Signals and Change
the Projected Image (Source Search)
Press the [Source Search] button to project images from the port currently
receiving an image.
Using Remote Control Using the Control Panel
When two or more image sources are connected, press the [Source Search]
button until the target image is projected.
When your video equipment is connected, start playback before beginning
this operation.
Projecting Images
45
To Next Page
Loading...
Need help?
General
