c
Select Quick Corner, and then press the [Enter] button.
When the message "If this setting is changed, the image may be
distorted."is displayed, press the [Enter] button again.
d
Select the corner to correct using the [ ], [ ], [ ], and[ ]
buttons on the remote control, or the [
w], [v], [Wide], and [Tele]
buttons on the control panel, and then press the [Enter] button.
e
Correct the position of the corner using the [ ], [ ], [ ], and
[
] buttons on the remote control, or the [w], [v], [Wide],
and [Tele] buttons on the control panel.
When you press the [Enter] button, the screen shown in step 4 is
displayed.
If the message "Cannot adjust any further." is displayed while
adjusting, you cannot adjust the shape any further in the direction
indicated by the gray triangle.
f
Repeat procedures 4 and 5 as needed to adjust any remaining
corners.
g
Press the [Menu] button to finish making corrections.
a
• If the [Esc] button is held down for about two seconds while
the corner selection screen from step 4 is displayed, the
following screen is displayed.
Reset Quick Corner: Resets the result of Quick Corner
corrections.
Switch to H/V-Keystone: Switches the correction method to
H/V-Keystone.
s "Settings Menu" p.122
Adjusting Projected Images
52
To Next Page
Loading...
Need help?
General
