3.2.3 Motors
Table 3-4. Motor Test Point
PF Motor
Motor connector No. CN10
Com-mon Pin No.
Test Pin No 1,2,3,4
Test Method
(Set meter to horms.
Disconnect the motor from
control board after the
printer is powered off.)
Place one lead on pin 1 and the other
lead on pin 3.
Place one lead on pin 2 and the other
lead on pin 4.
Meter Reading
16.1 Ω ± 10% (per phase, at 25°C)
CR Motor
Motor connector No. CN11
Com-mon Pin No. 5
Test Pin No 1,2,3,4
Test Method
(Same as for the PF
Motor)
Place one lead on pin 5 and the other
lead on each of 4 pins.
Meter Reading
2.7 Ω ± 10% (per phase, at 25°C)
3.2.4 Error Codes with Indications and Buzzer
Table 3-5. Error Codes with Indications and Buzzer
Indicators
Error
Condition
Pause
Paper
Out
Tear
Off/Bin
Pitch Font
Buzzer*
Paper out On On
❍ × 3
Paper jam
(Paper
ejected in-
completely)
On Blinks
❍ × 3
Head hot Blinks
Case open On
❍ × 3
Fatal error Blinks Blinks Blinks Blinks Blinks
● × 5
* : ❍ Indicates that the beep sounds for 100ms with an interval of 100ms.
● Indicates that the beep sounds for 500ms with an interval of 100ms.
To Next Page
Loading...
