4.2 DISASSEMBLY AND ASSEMBLY
This section describes procedures for disassembling and assembling the
main components of the printer. When the procedure for installing a
components is simply the reverse of removing the component, this chapter
dose not describe the assembly procedure. If necessary, special notes on
assembling or adjusting a component are given at the end of description of
each procedure. Be sure to follow the instructions in these notes.
Exploded diagrams in the Appendix shows how the components fit together.
Refer to them as necessary.
CAUTION
Before disassembling any part of the printer,
note the warnings in Section 3.1.
Before beginning to disassemble the printer,
remove the paper , ink ribbon, relevant parts,
etc.
Whenever the printer is repaired, wipe the
surface of the paper width (PW) sensor
assembly with a soft cloth, and keep it clean to
avoid abnormal operation. If the surface is dirty
from any adhering material, sensor sensitivity
goes down and operation is not correct.
The flowchart below shows the order to disassemble the printer.
START
Disconnect the printer's power
cord and interface cable.
Preparation for Disassembly
Removin
To Next Page
Loading...
