FX-2180 Service Manual Disassembly and Assembly
Rev. A
4-11
4.2.7 Removing the Upper Housing Assembly
1. Remove the printer cover, rear edge guide assembly paper eject
assembly and rear tractor unit. (Refer to Section 4.2.1.)
2. Remove the panel board assembly. (Refer to Section 4.2.2.)
3. Remove four CBB screws (4 × 4) securing the upper housing assembly.
4. Remove the platen knob.
5. Lift up the front side of the housing assembly by releasing 2 hooks from
the holes locates on the right and left of the front bottom side.
Figure 4-12. Releasing the Upper Housing Assembly Hooks
6. Remove the upper housing assembly.
Figure 4-13. Removing the Upper Housing Assembly
CHECK POINT
9
The tightening torque for the CBB screw : 0.98 ∼∼
1.22 Nm (10 ∼∼ 12 Kgf-cm)
To Next Page
Loading...
Need help?
General
