4.2.11.2 Disassembling the Paper Support Block Assembly
1. Remove the E-ring fixing the paper feed roller shaft to the right CSF
frame.
2. Remove two CTBS (3 × 8) screws securing the paper support shaft to
both right and left CSF frame.
E-ring
CTBS (3 x 8)
Paper Feed R oller
Paper Support R oller
R ight C S F Fram e
Figure 4-48. Removing E-ring and Screw
3. Remove both paper support assemblies along with the paper feed roller
shaft and paper support shaft.
4. Remove the paper feed shaft from both paper support assemblies by
pulling them toward the right or left side.
5. Remove both paper feed roller from the paper support assemblies.
6. Remove both CSF roller cover by releasing the clips fixing them to the
paper support assemblies.
7. Remove the paper support shaft by pulling out it toward the right or left
side.
Left CSF Roller Cover
Right CSF Roller Cover
Paper S upport S haft
Paper Feed R oller Shaft
Left Paper H older
R ight P aper H older
Left Paper Feed R oller
R ight Paper Feed R oller
Figure 4-49. Removing the Paper Feed Roller Covers
8. Remove the paper holder sliding it along the paper support shaft, and
then remove the paper holder spring from the paper holder.
CHECK POINT
9
Be careful to assemble the paper feed roller into
the proper side of the paper feed roller shaft.
Because, The right and left rollers are not
interchangeable each other.
To Next Page
Loading...
