Epson LQ 1050 - B/W Dot-matrix Printer - Carriage Motor Removal

REV.-A
4.2.5.4 Carriage Motor Removal
Step 1: Remove the printer mechanism (Refer to Section 4.2.5. 1.).
Step 2: Remove the carriage motor wires from the wire holder.
Step 3: Remove the timing-belt tension spring.
Step 4: Remove the two
CPS (0) (3 X 10) screws securing the carriage motor mounting plate to base
frame via carriage motor mounting bush.
Step 5: Remove the carriage motor mounting plate together with the carriage motor.
Timing Belt
Tension
SpI
Carriage Mot
Mounting Pla
Base
.ing
or-
lte
Fra
Figure 4-20. Carriage Motor Removal (1)
Step 6: Remove the four
CPS(0) (3 X 6) screws on the rear side of the carriage motor mounting plate,
which secure the carriage motor.
Carriage Motor
Carriage Motor
Mounting Plate
CPS (0~(3 x 6)
Figure 4-21. Carriage Motor
4-16
Removal (2)
-.-,
f
,.