Epson LQ 1050 - B/W Dot-matrix Printer - Paper End Detection

REV.-A
1.10 PAPER END DETECTION
The paper end is detected by the PE sensor. When the paper end is detected, the printer indicates it
by lighting the lamp on the control panel and ringing the buzzer. The printer sets the parallel interface
signals
as shown below, and enters the OFF LINE mode.
● BUSY signal: HIGH
● PE signal:
HIGH
. ERROR signal: LOW
After the paper end is detected, load a new sheet and press the ON LINE switch so that the printer enters
the ON LINE mode. Figure 1-10 shows the paper end detection position.
T
Approx.
59. 9mm
I
ABC
XYZ
Printable Area
.-. .------ — — ------------
Paper End Detection Posltlon
ABC XYZ
1...
---
Fig. 1-10. Paper End Detection Position
1-24