REV.-A
1.11.5 Housing
The housing consists mainly of the upper and lower cases. The components described in the former
sections (1. 11.1 through 1.11 .3) are accommodated in the lower case. Other components are the paper
feed knob, paper separator, and printer cover. The DIP switch position is changed from the rear side
of the printer (conventional) to the right side. A removable cover is located on the upper case so that
the DIP switches on the optional board can be set without removing the upper case.
Figure 1-17 shows the upper and lower cases.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
FX-850
FX-1 050
Figure 1-17. Housing
1-31
To Next Page
Loading...
