Epson LQ 1050 - B/W Dot-matrix Printer - Friction;Tractor Sensor Removal

REV.-A
4.2.5.8
Step 1:
Step 2:
Step
3:
Step 4:
Friction/Tractor Sensor Removal
Remove the printer mechanism (Refer to Section 4.2.5. 1.).
Position the paper release lever at its back setting.
Remove the paper feed motor (Refer to Section 4.2.5.7).
Remove the
CPS(P) (3 X 10) screw securing the friction/tractor sensor to the side frame R,
then remove the sensor.
(P) (3 x
10)
‘“” I ‘ /
. . .
I a’
I
Side Frame R
Frictionfiractor Sensor
Figure 4-27. Friction/Tractor Sensor Removal
ASSEMBLY POINT
Make sure of the sensor direction and set in place before mounting the friction/tractor sensor on
the side frame R.
4-21