REV.-A
4.2.5.10 Platen Unit Removal
Step 1: Remove the upper case (Refer to Section 4.2.1.).
Step 2: Remove the two CBNS (3
X
6) screws securing the platen cover to side frames L and R, then
remove the platen cover.
aft
Plate;
Cover
Platen
Figure 4-30. Platen Cover Removal
Step 3: Push on the right shaft holder clip, and rotate it forward.
Step 4: Remove the platen unit by moving it to the right side while pulling paper holding roller shaft
forward.
Right Shaft Holder
x
Platen
/
Figure 4-31. Platen Removal
4-23
To Next Page
