Epson LQ 1050 - B/W Dot-matrix Printer - Plunger Removal

REV.-A
4.2.5.9 Plunger
Step 1: Remove
Step 2: Remove
L.
Removal
the printer mechanism.
the RE (3), and disconnect
Step 3: Remove two
CPS (0)(3 X 6) screws,
loading lever of the plunger from the paper holding lever
which secure the plunger
to the side frame L, then remove
the plunger.
.,
i
--
Plu;ger
Loading Lever
—
Figure 4-28. Plunger Removal
ASSEMBLY POINTS
1. Mount plunger on side frame L by tightening the two
CPS (0) (3 X 6) screws lightly.
2. Set loading lever onto paper holding lever L, and put on RE (3).
3. Hold the
pulnger and cylinder as shown in Figure 4-29, and position it where move smoothly the
cylinder, and tight screws.
Figure 4-29. Plunger Positioning
f ‘“’
-.
4-22